Santa's Magic Key....This metal key has an aged look to make it look like an authentic old key. Some markings are to be expected, this is part of the aging process. Some may be a little wonky. This is how they are supposed to look. Please do NOT try and straighten them as you may snap the key.
Singles or Pks 10
Snowflake Red Ribbon
2 separate white sublimation discs*
Key length approx. 12cm
discs approx. 21mm diameter
snowflake charm attached.
*remember to remove the clear film before printing!!
You may already know how to sublimate onto metal but if you don't this is one way. Times & Temps may vary according to your heatpress.
Print your designs with a 2mm bleed so you get no white edges on the finished key.
Lay your sublimation paper with the design facing up and place your discs over the designs and secure with heat resistant tape.
Set your heat press for 190 degrees
Place your sublimation paper & discs onto the heatpress and cover with blow out paper. The discs should be on top of the paper still. This is fine as metal is a good conductor of heat.
Press for 60 seconds. BEWARE!! The metal will be VERY HOT!
Remove discs from the paper and using the double sided adhesive tabs provided, stick to your key.