Pk 10 Dreamcatchers

Dreamcatchers are hung above the beds of sleeping children to protect them from bad dreams and evil spirits. Legends say that the spider web design of the dreamcatcher would allow good dreams to pass through and float down the hanging beads and feathers to sleeping children

• Metal Dreamcatcher with sublimation disc
• Silver colour
• White ribbon included not a chain as seen in some pictures. 
• Zinc Alloy
• Approx. 8.5cm high
• Printing Area approx. 20mm
• As with all our metal designs, you can add a real photograph, print on vinyl or sub onto the disc included. A cabochon might look rather nice too.
• Spare discs may be available in our Clearance section.

Please Note.... Metal Alloys can tarnish and change colour over time and depending on where they are kept or if they get wet . Don't worry, this is normal. There are a number of ways you can clean your metal decoration. Soap and water would be my first choice for mild tarnishing. If this doesn't work, then try another method. Brasso or Silvo wadding is good. More natural methods include vinegar, baking soda and toothpaste.  You can find any of these methods on Google. 

You may already know how to sublimate onto metal but if you don't this is one way. Times & Temps may vary according to your heatpress.

1. Remember to remove the clear film before printing!!
2. Print your designs with a 2mm bleed so you get no white edges on the finished key.
3. Lay your sublimation paper with the design facing up and place your discs over the designs and secure with heat resistant tape. 
4. Set your heat press for 190 degrees
5. Place your sublimation paper & discs onto the heatpress and cover with blow out paper. The discs should be on top of the paper still. This is fine as metal is a good conductor of heat.
6. Press for 60 seconds. BEWARE!! The metal will be VERY HOT!
7. Remove discs from the paper and using the double sided adhesive tabs provided, stick to your key.